| JMB390 |
|
|
|
| 1 to 2-ports Serial ATA II Port Multiplier & RAID-0/1/10 Controller |
product brief
Overview
JMicron JMB390 is a single chip, 1 to 2-ports Serial
ATA II Port Multiplier with RAID function support.It is designed to provide
SATA port expansion, data protection and performance aggregation at various
applications.
JMB390 uses JMicron‘¦s production-proven Multi-port
Serial ATA PHY technology and JMicron-proprietary storage processor to provide
very high efficient SATA RAID operation. With an easy configuration scheme,
the device can be a pure port multiplier which provides SATA port expansion
just like a SATA Hub, or hard-drive performance booster which provides a high
performance device seen by host controller or hard-drive data protector which
automatically backup data to prevent data loss from hard-drive damage.
JMB390 is a self-contained storage processor chip which
completely frees up the main CPU loading and the SATA ports comply with eSATA
specification, making it suitable for use in both internal system and external
storage applications
|
| |
Feature
Compliance
Compliant with Serial ATA II Port Multiplier Spec. Revision 1.1
Compliant with Serial ATA II PHY Electrical Spec. Revision 1.0
Compliant with Serial ATA High Speed Serialized AT Attachment Spec. Revision 2.5
|
| |
General
Integrated 3-port SATA II PHY
Integrated PLL for SATA II interface
Total six independent SATA channel
Integrated uP, PROM and SRAM for firmware programming
Integrated high performance RAID storage processor
1.3V core and 3.3V I/O power supply
Available in 48-pin QFN package
|
| |
SATA
Supports 3-port 3.0Gbps SATA II interface
Supports SATA II Gen2i and Gen2m (External SATA Connection, eSATA)
Output swing control and automatic impedance calibration for SATA II PHY
Supports asynchronous signal recovery
Supports spread spectrum clocking
Supports partial / slumber power saving mode
Automatically speed negotiation for 3 Gbps or 1.5 Gbps
Supports BIST and loopback mode
Supports staggered spin-up
Supports 48-bit LBA addressing
Supports ATAPI drives
Supports Native Command Queue (NCQ)
Supports Hot-Plug
Supports Asynchronous Notification
Supports PM aware and non-PM aware host
|
| |
RAID
Fully hardware-accelerated RAID Engine
No driver, BIOS or software required for RAID operation
No external DRAM or processor required for RAID operation
Independent of device SATA port connection sequence
Supports RAID levels: 0 / 1 / JBOD
SATA In-band application interface
Supports more than 2Tera Bytes RAID drive
Supports on-line read data integrity check
Supports on-line command based bad sector recovery
Supports on-line Auto-Rebuild
Rebuild speed: 200GB/hour
Rebuild proceed continuously between power cycling
|
| |
GPIO
Supports 15 GPIOs
Supports I2C interface
Supports ISA interface
Supports SPI interface
Supports LED indicators
Supports LCD panel
Supports dual external firmware protection
|
| |
Application
RAID Subsystem
NAS Servers
Backup Systems
Disk Clone Systems
Serial ATA Enclosures
Large Capacity & High Performance Solid State Drive
Very Large Capacity Disk Systems
SATA Ports Expander
|
| |